accelerometers
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
accelerometers [2013/11/22 14:46] – sysop | accelerometers [2019/10/03 09:22] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | **Accelerometers**\\ | ||
+ | \\ | ||
+ | **Warning: MMA7260Q and MMA7361L accelerometers operate on a 3.3 volt powersupply! Do not use 5 volt.**\\ | ||
+ | \\ | ||
+ | Triple Axis Accelerometer Breakout - MMA7260Q\\ | ||
+ | {{tri-ax_mma7260q.jpg:? | ||
+ | {{tri-ax-schematic-v01.pdf | schematic}}\\ | ||
+ | {{mma7260q-rev1.pdf | manual}}\\ | ||
+ | \\ | ||
+ | \\ | ||
+ | Triple Axis Accelerometer Breakout - MMA7361L\\ | ||
+ | {{mma7361.jpg:? | ||
+ | This is a breakout board for Freescale' | ||
+ | {{mma7361-schematic.pdf | schematic}}\\ | ||
+ | {{mma7361l_data_sheet.pdf | manual}}\\ | ||
+ | {{tilt_sensing_using_a_three-axis.pdf|application note}}\\ | ||
+ | \\ | ||
+ | |||
+ | |||
+ | **MPU-6050 Accelerometer + Gyro**\\ {{ :: | ||
+ | \\ | ||
+ | The MPU-6050 devices combine a 3-axis gyroscope and a 3-axis accelerometer on the same silicon die, together with an onboard Digital Motion Processor™ (DMP™), which processes complex 6-axis MotionFusion algorithms. The device can access external magnetometers or other sensors through an auxiliary master I²C bus, allowing the devices to gather a full set of sensor data without intervention from the system processor.\\ | ||
+ | \\ | ||
+ | http:// | ||
+ | \\ | ||
+ | https:// | ||
+ | {{:: | ||
+ | {{:: | ||
+ | {{:: | ||
+ | |||
+ | |||
+ | |||